Rebuild sequence -- MOA - Bulletin Board

[ Show ]

Support VoyForums

[ Shrink ]

VoyForums Announcement: Programming and providing support for this service has been a labor of love since 1997. We are one of the few services online who values our users' privacy, and have never sold your information. We have even fought hard to defend your privacy in legal cases; however, we've done it with almost no financial support -- paying out of pocket to continue providing the service. Due to the issues imposed on us by advertisers, we also stopped hosting most ads on the forums many years ago. We hope you appreciate our efforts.

Show your support by donating any amount. (Note: We are still technically a for-profit company, so your contribution is not tax-deductible.) PayPal Acct: Feedback:

Donate to VoyForums (PayPal):

Sun, December 22 2024, 01:08 [ Login ] [ Contact Forum Admin ] [ Main index ] [ Post a new message ] [ Search | Check update time | Archives: 1, 2, 3, 4, 5, 6, 7, 8, [9] ]

[ Next Thread | Previous Thread | Next Message | Previous Message ]

Date Posted: - Sunday - 01/ 7/07 - 7:19pm
Author: Pete
Subject: Rebuild sequence
In reply to: Randall, M31, Murre 's message, "Sequence on Murre" on - Wednesday - 08/ 9/06 - 9:57pm

Randall, would you be able/willing to either email me or post an image taken from the interior of your cabin that shows the cabin side butt block? -- I'm wondering how it looks as I am doing the same project now. -- I am also wondering how much "camouflage" it may require.

Many thanks, Pete

"Obviously you�ll only have access to 4 x 8 sheets for the cabin side, so will have to decide were to put the seam. We put it at the split in the split cabin�i.e. where the cabin goes from being raised to not raised. On the inside of the seam we installed a butt block of 1� by something or other mahogany."

[ Next Thread | Previous Thread | Next Message | Previous Message ]

Replies:

[> [> [> Cabin Sides Butt Block -- Randall, Murre, M31, - Monday - 01/ 8/07 - 4:00pm

Here you go. The attached photo is of the interior of the new cabin side, port side facing forward. You can see that the cabin sides joint (under the butt block) is just forward of the step for the raised cabin.

The block is approximately 3� wide (maybe 4�) and about 1� thick. It extends all the way down to the bottom of the drip rail, but has a small notch cut out lengthwise so that my electrics for the main mast radio antennae can pass through on their way forward, and water (if things are going badly) can pass aft. The piece is glued and then screwed to the cabin sides from the exterior. This leaves the interior sides of the block looking clean.

One might ask why the block wasn't bolted as were the butt blocks at the joints of the old deck. The answer would be that we applied several layers of 1.5 oz glass over the whole of the cabin side's exterior, which means the butt block isn't carrying all the joint's strength.

The wood is Santa Maria (somewhat similar to Mahogany). I painted the interior of the cabin sides white, but varnished the butt block as it�s a pretty nice looking piece and matches the other structure and trim pieces of the cabin interior.

Remember, you can click on the below image to enlarge it.

Hope this helps,

RR

[ Edit | View ]

[ Contact Forum Admin ]

Forum timezone: GMT-5
VF Version: 3.00b, ConfDB:
Before posting please read our privacy policy.
VoyForums^(tm) is a Free Service from Voyager Info-Systems.
Copyright © 1998-2019 Voyager Info-Systems. All Rights Reserved.