Re: looking for info -- Eye In The Sky

[ Show ]

Support VoyForums

[ Shrink ]

VoyForums Announcement: Programming and providing support for this service has been a labor of love since 1997. We are one of the few services online who values our users' privacy, and have never sold your information. We have even fought hard to defend your privacy in legal cases; however, we've done it with almost no financial support -- paying out of pocket to continue providing the service. Due to the issues imposed on us by advertisers, we also stopped hosting most ads on the forums many years ago. We hope you appreciate our efforts.

Show your support by donating any amount. (Note: We are still technically a for-profit company, so your contribution is not tax-deductible.) PayPal Acct: Feedback:

Donate to VoyForums (PayPal):

[ Login ] [ Contact Forum Admin ] [ Main index ] [ Post a new message ] [ Search | Check update time | Archives: 1 ]

[ Next Thread | Previous Thread | Next Message | Previous Message ]

Date Posted: 01:54:24 12/01/02 Sun
Author: Zargon
Subject: Re: looking for info
In reply to: fujii 's message, "looking for info" on 16:15:33 11/30/02 Sat

"Programming AVR with Autoroll"
----------------------------------------
** If your "EEPROM" has been programmed before and you are just adding a new PFG.File then skip steps 3 & 4.
----------------------------------------

1) Put Cam (Smart Card) in IRD (Receiver) alone for several minutes While you are programming "AVR"
2)In Jeeper's Select "Turnip 4.99_E", "expressvu" & "married sub "
----------------
This programs the "Autoroll Chip"
3) Open Jeepers......Go in "Amtel8515" and click "Erase Eeprom".
4) Go up to......"12C EEPROM" on your Jeeper's and click "Write AREEP200" (takes about 4 minutes)
--------------------
5) Click "get" next to keys
6) Copy Active Aux # into "Public Key"
7) Click which "Aux" is "Active" under "Public Key"
8) Fill in Ird and Cam ID #'s
9) Select time zone
10) Zip code 0
11) Leave everything else the same (default)
12) Then do a "Full Monty"
13) Read "AVR" to ensure all is fine
-------------------------------------------

If you run into any problems here are a few things you can "Check Out".
-----------------------------
1) Make sure Smart Card (Cam) is in the AVR the right way.
2) Clean contacts on AVR and Cam with pencil eraser.
3) Do a "Read" on your AVR with Jeeper's to make sure all Info #'s are
correct.
4) Leave Cam in receiver a bit longer to make sure it has picked up correct
"Active Keys".Then replace "Public Key" with "Active Key" (check of Radio
Button below Public Key) and Full Monty.

Hope this helps.

[ Next Thread | Previous Thread | Next Message | Previous Message ]