Re: HANDLEBAR INSERTION -- The Raleigh Chopper Message board

[ Show ]

Support VoyForums

[ Shrink ]

VoyForums Announcement: Programming and providing support for this service has been a labor of love since 1997. We are one of the few services online who values our users' privacy, and have never sold your information. We have even fought hard to defend your privacy in legal cases; however, we've done it with almost no financial support -- paying out of pocket to continue providing the service. Due to the issues imposed on us by advertisers, we also stopped hosting most ads on the forums many years ago. We hope you appreciate our efforts.

Show your support by donating any amount. (Note: We are still technically a for-profit company, so your contribution is not tax-deductible.) PayPal Acct: Feedback:

Donate to VoyForums (PayPal):

[ Login ] [ Contact Forum Admin ] [ Main index ] [ Post a new message ] [ Search | Check update time ]

Subject:

Re: HANDLEBAR INSERTION

Author:
TCSE

[ Next Thread | Previous Thread | Next Message | Previous Message ]

Date Posted: 20:09:50 09/17/03 Wed
In reply to: PROPPER CHOPPER 'BO' I TELL THEE 's message, "HANDLEBAR INSERTION" on 19:29:37 09/17/03 Wed

I am sure I mailed this to you but here goes>>

So cups fitted bearings in screw on the large head nut so:- tighten finger tight make sure the forks turn freely and then fit the lamp bracket.
Now the tricky bit. Ever wondered what that groove is in the back of the handlebar tube?
you will need to slide the small head nut up the handlebar tube like so:-
Slot the bars in the forks so:--
Place a ball bearing same as in the groove then screw down the nut finally do all the nesarcery adjustments and bingo another bit of chopper built.

[ Next Thread | Previous Thread | Next Message | Previous Message ]