VoyForums
[ Show ]
Support VoyForums
[ Shrink ]
VoyForums Announcement: Programming and providing support for this service has been a labor of love since 1997. We are one of the few services online who values our users' privacy, and have never sold your information. We have even fought hard to defend your privacy in legal cases; however, we've done it with almost no financial support -- paying out of pocket to continue providing the service. Due to the issues imposed on us by advertisers, we also stopped hosting most ads on the forums many years ago. We hope you appreciate our efforts.

Show your support by donating any amount. (Note: We are still technically a for-profit company, so your contribution is not tax-deductible.) PayPal Acct: Feedback:

Donate to VoyForums (PayPal):

Roofing and Siding since 1985
Sat, May 16 2026, 1:49pm [ Login ] [ Main index ] [ Post a new message ] [ Search | Check update time | Archives: 1, [2], 3 ]
[ Next Thread | Previous Thread | Next Message | Previous Message ]

Date Posted: Tue, Nov 19 2002, 3:15pm
Author: homedude
Subject: Re: Flat roof repair- torching it - rubberizing HELP
In reply to: A Roofer 's message, "Re: Flat roof repair- torching it - rubberizing HELP" on Sun, Nov 17 2002, 6:32am

Two years ago I hired out my low pitch dormer roof. 30 x 24, 1/12 pitch. Had rolled roofing, one layer. Leaked like a sieve. I looked at torch-down asphalt, but liked the durability of EPDM. I went with full adhesion fibre re-inforced 1/16" thick EPDM. This was a two day job for 2 pros. Strip of 1 layer rolled, clean the deck, attach substrate ( a spongy wood/paper board to provide support and impact give/resistance) and glue and stick two 12' wide passes of EPDM. Only had 1 protrusion to go around. Total cost was $3500. Not cheap, but a professional job that will last at least 10-15 years and is way easier to patch ( i.e. more EPDM and some rubber cement ) than torch-down asphalt ( i.e. tar and pray ). Looking back I could have done the EPDM myself, but the artwork was the metal flashing to secure it at the edges where it is most vulnerable. That was best left to pros with more patience with metal forming than I. Good Luck!

[ Next Thread | Previous Thread | Next Message | Previous Message ]

Forum timezone: GMT-8
VF Version: 3.00b, ConfDB:
Before posting please read our privacy policy.
VoyForums(tm) is a Free Service from Voyager Info-Systems.
Copyright © 1998-2019 Voyager Info-Systems. All Rights Reserved.